Revisions to G2 Front Bodywork

We have taken away the square corners of the front fenders and reprofiled the inner fender bulges.

We have added an air intake to the front and carried body contour lines rearward from there to blend in to the existing contour lines of the center section and tail.

This raised center vent will have an air outlet on the vertical panel that is seen in green.

The nose section had previously been six seperate sections.  Two of which were bolted to the frame.  The rest were attached independently.  To keep better structural integrity, but still maintain the component replacement aspect, we elected to use bolts/rivets to semi-permanently assemble the now four pieces which will be attached to the car as a single unit with two quickpins.